Tools

1/2 Round Punch for Bergeon 6620 is a replacement cutter for item # 64-6620. The cutter is available in 2 mm, 4 mm and 6 mm. This is a great tool t...

Ball Bearing only Horotec 10.500 Bracelet Press This is the ball bearing that fits into the sleeve at the top of the Horotec bracelet press 10.500 ...

Bergeon Bracelet Pin and Spring Bar Removing Tool This parallel action plier allows you to drive out watch bracelet pins and is also ideally suited...

Bottom Die for Bergeon 6620 This bottom die is held in place with a thumb screw. Over time these dies can become worn, which results in an uneven c...

Broach Holder for Pins Horotec 10.500 Bracelet Press This is the broach (holder) only that accepts the 11 different diameter of pins for driving ou...

Cracked Base for Screwdriver Blade The cracked base holds the screwdriver blade in the bottom of the Bergeon 6745-100 Bracelet Press.

Cruciform Blade for Bergeon 6745-100 Cruciform (Phillips) Blade is a replacement blade for the Bergeon 6745-100 item # 64-6745-100 bracelet press. ...

Economical Plier to Remove Rivet Bars is an economical version of the plier designed to remove pressure type (Gucci type) bars from watch bracelets...

Flat Nylon Stake for Bergeon 6578 Pin Tool This flat nylon stake for Bergeon 6578 Bracelet Pin and Spring Bar removing tool. This is the nylon flat...

Lower Support Horotec 10.500 Bracelet Press (item # 67-10500) is the support (holder) that fits into the bottom of the press to hold the slotted hi...

O-Ring Gasket Horotec 10.500 Bracelet Press (item # 67-10500) is a replacement O-ring gasket that fits on the broach (holder) for the pins as well ...

Rectangular Punches for Bergeon 6620 This rectangular punch is available in 2 mm, 4 mm and 6 mm and fits the Bergeon 6620 strap cutting (notching) ...

Replacement Pins for Horotec 10.500 these pins are available in 0.40 mm, 0.60 mm, 0.70 mm, 0.80 mm, 0.90 mm, 1.00 mm, 1.10 mm, 1.20 mm, 1.40 mm, 1....